Integrated commodity supply & global logistics

+971 4 250 0715

Buyer guide

Gearmotor Enquiries: Locate the Radial Load on the Output Shaft

A replacement gearmotor enquiry may include torque and output speed while leaving the pulley or sprocket position off the drawing. That omission matters when a supplier checks the permitted load on the output shaft. A catalogue force limit needs its stated point of application before purchasing can use it to compare a proposed arrangement.

Read the application point behind the catalogue limit

SEW-EURODRIVE's February 2026 DRN gearmotor documentation explains that off-centre force application requires a permitted-load calculation for the actual distance. For the cited solid-shaft tables, the published maximum values refer to force applied halfway along the shaft end. The manual defines the distance reference from the shaft collar for a solid shaft.

Use that as a reason to request the selection drawing and its reference points. Do not assume that every manufacturer's table uses the same position. Ask the supplier to identify the point of application behind its quoted limit and the arrangement assessed for the offered model.

Reference: SEW-EURODRIVE: output-side overhung loads with off-centre force application

Keep the force and its distance in one drawing revision

Mark the applied force, its direction, units and distance on a dimensioned drawing. Identify the reference surface used for that distance rather than writing an isolated millimetre value in an email. Include the proposed pulley, sprocket or other transmission element so the reviewer can locate the load.

Keep torque and any separately identified radial or axial loads visible as different inputs. Ask the responsible engineer to resolve missing load information. Purchasing should carry the approved inputs into the enquiry and comparison sheet without inventing a load from motor power alone.

Ask what governs the permitted value

In the cited manual, the permitted off-centre overhung load is the lower of the value associated with bearing service life and the value associated with shaft strength. A single catalogue number should therefore stay attached to its model, conditions and selection reference.

Request the supplier's assessment for the actual configuration, including the applicable operating assumptions and any unresolved inputs. Avoid creating a universal distance correction in the quotation spreadsheet. The buyer's useful record is the confirmed arrangement and the technical approval supporting it, rather than an unsupported recalculation.

Reopen the check when the transmission element moves

Consider a hypothetical replacement in which a spacer moves the pulley outward to clear a guard. The torque requirement may be unchanged, but the earlier assessment described a different load position. Send the revised drawing back for confirmation before treating the replacement proposal as technically approved.

For a Zenith Eclipse sourcing enquiry, provide the application, required output speed and torque, load information, mounting arrangement, drawing revision, quantity and destination. Ask the supplier to link its offered unit to the reviewed configuration. Equipment availability, specifications and the supply scope require confirmation in the individual offer.

Discuss your requirements

Discuss the gearmotor sourcing requirement

Send the application and drawing: sales@zenitheclipse.com

sales@zenitheclipse.com

Explore all Insights